I spent almost 3 hours playing around with other Vallejo colors and I saw that I didn't have the same problem with them, just black.
Something to note for the future!
alexbb wrote:you are getting there joe now try and use an even lighter grey on smaller areas, and if you want an even more lighter grey. with filters and washes they will blend in together and darken a bit.
jojjemannen wrote:I did spray (read: I tried) a lighter gray colour on the upper hull but it looks terrible!
The lighter gray is too gray so it looks horrendus!
I can't seem to get that fading effect that you guys can achive!
jojjemannen wrote:I did spray (read: I tried) a lighter gray colour on the upper hull but it looks terrible!
The lighter gray is too gray so it looks horrendus!
I can't seem to get that fading effect that you guys can achive!
alexbb wrote:
always use the base colour, lightening or darkening it with white or black gradually, make sure the paint is quite thinned otherwise you will only be respraying and not highlighting/lowlighting
alexbb wrote:
The last AFV I sprayed I used the AK Grey Modulation set and it really helped. There you have the correct shades of grey to work with.
bcauchi wrote:Dont be afraid to overdo it at this stage. Make sure that if you are darkening then darken a lot and if you are putting in highlights they have to really be obvious. Your work is nearly lost because there is no contrast at all between the grey you had and the colours you used to post shade and highlight. That is why i told you to first post shade and highlight and then go over it again with the original colour. You will overdo the post shading and highlighting and then get the right amount of contrast you need when you respray with the original colour. That is why it has to be really thinned down so that you don;t get a coat but will blend in the colours gradually and you will have full control till you get the effect you need. Try it out it is quite easy.
Dottore wrote:I think the problem you've been having with preshading comes from the fact that the Vallejo paints are very opaque, so they don't leave enough of the preshade showing. I usually use Tamiya paints and dilute 60-70% with thinner so I can build up the intensity of the colour gradually to a shade that I am comfortable with. Also remember that the model will always darken after filters and washes so you actually WANT a pale shade of the colour you desire at the end.
Still it's looking quite good, just go ahead with the other techniques and get a finished model under your belt...
Looking forward to more!
Dottore
alexbb wrote:now this is just my opinion re chipped areas. i would prefer the light coloured chipping be much less than the dark. i would use the light colour to enhance the dark chipping
this might give you an idea
http://migjimenez.blogspot.com/2012_01_01_archive.html
jojjemannen wrote:alexbb wrote:now this is just my opinion re chipped areas. i would prefer the light coloured chipping be much less than the dark. i would use the light colour to enhance the dark chipping
this might give you an idea
http://migjimenez.blogspot.com/2012_01_01_archive.html
And not the way I've done it by having the dark colour to enhance the light chipping?
alexbb wrote:jojjemannen wrote:alexbb wrote:now this is just my opinion re chipped areas. i would prefer the light coloured chipping be much less than the dark. i would use the light colour to enhance the dark chipping
this might give you an idea
http://migjimenez.blogspot.com/2012_01_01_archive.html
And not the way I've done it by having the dark colour to enhance the light chipping?
we all make mistake JOE beleive me i know, i am mr mistakes lol
|
|